Benne à bâche

Fliegl SDS 350 MegaRunner

Fine-grain steel welded construction, kingpin assembly with two replaceable kingpins.
Note: With a frame neck height of 30 mm, the truck wheelbase must not exceed 3700 mm!
Outer frame slightly angled with load-lock profile for attaching lashing straps. Note: To attach the straps in conjunction with side walls, the side walls must be opened! Not in the neck area! 10 pairs of lashing eyes recessed into the outer frame, each with a capacity of 2.5 tons. Outer frame with load-lock profile for attaching lashing straps. Note: Not usable with side walls! 24 tons. Two-stage support jacks, single-sided operation, with a straight lower section, without thrust compensation, folding supports at the front, extending outwards and folding downwards in front of the front wall. Retracted as far as possible inwards in the driving position (for uncoupling under load), without supports, extension ladder at the rear, door lock on the side, shims with holder, aluminum side impact protection, galvanized steel underrun protection, quarter panel fenders in front of the first axle and behind each axle, with anti-splash flaps behind each axle, rear impact protection.
Heavy-duty rear impact protection beam, pallet stop in heavy-duty design on both sides, approximately 20-25 mm high, with lashing capability every 200 mm, loading height reduced by approximately 20-25 mm, plastic tool box.

SAF disc brake axles, air suspension, without lift axle.

Two-line compressed air brake system, spring brake parking brake, 2 non-interchangeable coupling heads at the front, without connection line, EBS, electronic braking system with EBS socket at the front, without connection cable. Attention: The trailer may only be pulled by tractor units which ensure the effectiveness of the ABS! With raise and lower valve, vehicle - driving stability system.

24 Volt, multi-chamber lights, yellow LED lighting on the sides, 2 white position lights at the front.
2 white/red marker lights at the rear, 2 x 7-pole and 1 x 15-pole non-interchangeable sockets at the front, without connection cable.

Floor: Front area with steel floor and anti-slip coating, plywood panels approximately 30 mm thick, crossbars with omega insert, on longitudinal beams for high point load capacity for forklift axle load up to max. 7100 kg, in the wheel area steel/diamond plate covering.

Front wall/corner posts: 2,580 mm high, corner posts made of steel in volume design, release mechanism for side tarpaulin on front wall, at the bottom inside at approximately 140 mm height with steel impact protection.

Center posts: 3 pairs of sliding posts, slidable over the entire length, with 4-fold insertion pockets and a long pocket at the bottom, 3 pairs of post positions, aluminum insertion slats.

Hsdpjkyrlwefx Ac Nsp
Rear corner posts made of steel up to the lower edge of the roof, attachment for tarpaulin with round tube and tarpaulin tensioning ratchet, rear portal doors, 2-leaf with 2 internal swivel rod locks each.

Tarpaulin with welded-in horizontal and vertical straps, tensioning buckles made of stainless steel, customer lettering on rear portal.

Roof: Sliding tarpaulin, rear end lift that folds up, with the tarpaulin slidable from back to front, L-shaped roof beam for the automotive industry, internal width between the roof beams approximately 2,490 mm, tarpaulin color: white, EcoLift - liftable roof, can be raised by approximately 380 mm, with gas spring support, anti-ice system, with one hose in the center, with automatic ventilation.

L'annonce a été traduite automatiquement et des erreurs de traduction peuvent apparaître.